EasyManua.ls Logo

Shining 3D EINSTAR - Step 1: Connect the Cable

Shining 3D EINSTAR
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connect Your Scanner
STEP 1
STEP 2
STEP 3
Connect Your Scanner
02
STEP 1
Align the plug of the cable into the bottom jack
of the Einstar.
The red dot should be
consistent with the front
side of the scanner.
When unplugging, make sure
to pinch the of METAL END
the cable instead of the rubber
part.
Note:

Table of Contents

Related product manuals