Need help?Do you have a question about the Shott BP-35WS-B and is the answer not in the manual?
Declaration of conformity with relevant EU directives and harmonised standards.
Details the general terms and conditions of the product warranty.
Outlines specific conditions for warranty validity and coverage.
Lists limitations and exclusions applicable to the warranty coverage.
Describes the intended use and application of the SERIES BP heat pumps.
Instructions for inspecting the heat pump upon delivery and checking packaging integrity.
Guidelines for safely handling the heat pump unit during installation and unpacking.
Specifies requirements and considerations for selecting the optimal installation location.
Details on selecting a suitable support and the installation site requirements.
Guidelines for the proper disposal of packaging and replaced parts.
Instructions for safely decommissioning and disposing of the heat pump at end-of-life.
Important warnings and recommendations for performing hydraulic connections safely.
Illustrates the general layout for connecting the heat pump within the pool's hydraulic system.
Crucial precautions to be taken before starting the heat pump system.
Essential checks to perform before the very first start-up of the heat pump.
Overview of the heat pump's control system and its energy-saving features.
Detailed explanation of the heat pump's control panel and its interface.
Instructions on how to safely turn on the heat pump using the protection device.
Explanation of the heat pump's standby mode and what is displayed.
Procedure for safely turning off the heat pump.
Sets the acceptable range for pool water temperature regulation.
Configures the ambient temperature at which automatic defrost begins.
Sets the heat exchanger temperature for stopping the automatic defrost cycle.
Determines the interval between automatic defrost cycles.
Sets the time duration for both automatic and manual defrost cycles.
Configures the maximum temperature limit for compressor protection.
Enables automatic restart of the previous operating mode after a power outage.
Selects the primary operating mode of the heat pump (heating, cooling).
Sets the maximum allowed deviation from the target pool temperature.
Selects the control mode for the heat pump or heater.
Describes the sensors and devices that control the heat pump's operation.
Information on ambient and pool water temperature sensors and their function.
Details the flow sensor used to monitor water flow rate.
Describes sensors for monitoring compressor and heat exchanger temperatures.
Explains the function of the high pressure sensor in protecting the compressor.
Details the low pressure sensor and its role in compressor protection.
Periodic checks and maintenance tasks that users can perform.
Maintenance tasks that require a qualified technician.
Instructions for protecting the heat pump during the winter season.
Steps for recommissioning the heat pump after winter storage.
Important notes and procedures before replacing parts on the heat pump.
Instructions for safely replacing the manometer on the heat pump.
Procedure for replacing the pressure sensor, including necessary tools.
Guidelines for replacing the filter and capillary components.
Troubleshooting step for frost on the radiator, involving refrigerant pressure check.
To Next Page
General
