Shure AD Series - Matching Audio Levels with Offset; Troubleshooting

Shure Incorporated
17/26
2.
3.
1.
2.
3.
Set the frequency to 400 Hz or 1000 Hz.
Select Level and use the arrow buttons adjust the value between -60 dB and 0 dB.
Turn off the tone by selecting Off from the menu or by cycling the transmitter power.
Matching Audio Levels with Offset
When linking two or more transmitters to a receiver, there may be a difference in volume levels between microphones or instru
ments. If this occurs, use the Offset function to match the audio levels and eliminate audible volume differences between trans
mitters. If using a single transmitter, set Offset to 0 dB.
Turn on the first transmitter and perform a sound check to test the audio level. Turn off the transmitter when finished.
Turn on the second transmitter and perform a sound check to test the audio level. Repeat for any additional transmit
ters.
If there is an audible difference in the sound level between the transmitters, navigate to the Offset menu (Audio >
Offset) in the transmitter to increase or decrease the Offset in realtime to match the audio levels.
Troubleshooting
Issue See Solution...
No sound
Power, Cables, Radio Frequency, or Encryp
tion Mismatch
Faint sound or distortion Gain, Cables
Lack of range, unwanted noise bursts, or dropouts Radio Frequency (RF)
Cannot turn transmitter off or change frequency settings, or can't pro-
gram receiver
Interface Locks
Encryption Mismatch message Encryption Mismatch
Firmware Mismatch message Firmware Mismatch
Transmitter Battery Hot message Tx Battery Hot