Shure Incorporated
5/24
◦
◦
View menu screens and settings. Press any control button to activate the backlight.
③ Infrared (IR) Port
Align with the receiver IR port during an IR Sync for automated transmitter tuning and setup.
④ Control Buttons
Use to navigate through parameter menus and to change settings.
⑤ Battery Compartment
Requires two AA batteries or Shure SB900A rechargeable battery.
⑥ AA Battery Adapter
Use to secure AA batteries. Remove when using a Shure SB900A battery.
⑦ SMA Connector
Connection point for RF antenna.
⑧ Power Switch
Powers the unit on or off.
⑨ Power LED
Green = unit is powered on
Red = low battery, Mute Mode enabled, input overload, or battery error (see Troubleshooting)
⑩ Input Jack
Connects to a 4-Pin Mini Connector (TA4F) microphone or instrument cable.
Note: A LEMO connector model variation of this transmitter is available.
To Next Page
Loading...
