Shure Incorporated
44/103
•
•
•
•
1. Go to the Configuration
Tab
Assign the devices to groups from the Configuration tab of the MXW control software.
2. Select the Access Point
Transceiver (APT) for
Group 1
Select an APT to determine group channel count (2, 4 or 8).
Group 1 automatically uses the APT opened from the Web Discovery application. Other networked (and open) APTs
are available for additional groups.
3. Select the Network
Charging Station(s)
Select one or two Network Charging Station (NCS) to the access point. An additional charg
er can be added to the group:
When using multiple smaller chargers to fill the channel count of the group. For exam
ple, two 4-channel chargers for an 8-channel group.
When using gooseneck microphones. Gooseneck mics cover the front and back slots of
a charger, halving the number of slots available. For example, two eightchannel charg
ers are required to fill an eight-channel access point with gooseneck microphones.
4. Select the Audio Output
Device(s)
Select one or two audio output devices (MXWANI or SCM820) to automatically route the dig
ital audio channels from the access point. Select from the following devices:
Audio Network Interface (MXWANI) four- or eight-channel variation.
Shure SCM820 IntelliMix Mixer. Dante-enabled SCM820s can be selected as the audio
output for the Group. This automatically routes the SCM820's aux input to the micro
phones for personal monitoring (SCM820 aux left channel to MXW channels 1 - 4; aux
right channel to MXW channels 5 - 8).
Note: Component group and microphone link data are persistently stored in each device. If the MXW system is shut off and then restarted without a computer,
the devices will remain associated to the access point.
®
To Next Page
Loading...
Need help?
General
