Shure P3RA Manual

SB900Shure Lithium-Ion Rechargeable Battery
65A15224AA battery adapter
SE112Dynamic MicroDriver earphones
SE215Dynamic MicroDriver earphones
SE315High-definition MicroDriver earphones with tuned bass
port
SE425High-definition earphones with dual MicroDrivers
SE535High-definition earphones with triple MicroDrivers
SE846High-definition earphones with quad MicroDrivers
SBC-DCPower a SB900-compatible bodypack with an AC
power supply instead of batteriesDC Power Insert
(Battery Eliminator)
RPW503Single Rack Mount Kit
RPW504Dual Rack Mount Kit
Certifications
Meets essential requirements of the following European Directives:
• Low Voltage Directive 2006/95/EC
Conforms to the relevant requirements of regulation (EC) No.278/2009, for
low voltage external power supplies.
Meets essential requirements of the following European Directives:
• WEEE Directive 2002/96/EC, as amended by 2008/34/EC
• RoHS Directive 2011/65/EU
Note: Please follow your regional recycling scheme for batteries and
electronic waste
This product meets the Essential Requirements of all relevant European di-
rectives and is eligible for CE marking.
Hereby, Shure Incorporated declares that the radio equipment is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: http://www.shure.com/eu-
rope/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: EMEAsupport@shure.de
P3RA
Approved under the Declaration of Conformity (DoC) provision of FCC Part
15.
Complies with requirements set out in RSS-GEN.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any inter-
ference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Shure IncorporatedP3RA Professional Wireless Bodypack Receiver
7/7
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com

Shure P3RA Specifications

General

Display	LCD
Housing	Metal
Image Rejection	> 90 dB
Adjacent Channel Selectivity	>70 dB
Intermodulation Attenuation	>70 dB
Blocking	> 80 dB
Tuning Steps	25 kHz
Type	Bodypack
Frequency Range	470 - 952 MHz
Audio Output Power	100 mW (at 1 kHz, <1% distortion, typical)
Dimensions	99 mm x 66 mm x 23 mm
RF Frequency Range	470 - 952 MHz
RF Sensitivity	2.2 μV at 20 dB SINAD
Minimum Load Impedance	16 Ω
Headphone Connector	3.5 mm
Battery Type	SB900A
Audio THD	< 0.5%
Power Requirements	2 AA batteries or Shure SB900A rechargeable battery
Dimensions (inches)	3.9 x 2.6 x 0.9
Net Weight	196 g (with batteries)