6
P6R Receiver
Controls and Connectors
ÐÊË
Ì
Í
Ï
Ê
ÑÎ Ò
Ó
Î Ï
Ó
Ê
Balance Dial. In stereo mixes, this controls the
left/right balance. In MixModet, this controls the
mix level of two transmitter inputs.
Ë Headphone Connector. 3.5 mm (
1
/
8
-in.) jack
connects to the earphones. Left=tip, right=ring,
ground=sleeve.
Ì LOW BATT Indicator. This red LED illuminates
when the battery has approximately 45 minutes of
operating time remaining, depending on the
volume.
Í Power LED. This green LED illuminates when the
power is ON and the battery is good.
Î ON/OFF and Volume Dial. Full counter-clockwise
turns the P6R OFF. Turn the dial clockwise past the
click to turn the P6R ON. Once ON, turn the dial
clockwise to raise the volume, and
counter-clockwise to lower the volume in the
earpieces.
Ï Antenna and Connector. An easily removable
antenna connects to the P6R to receive RF signals
from the P6T Transmitter.
Ð RF LED. Illuminates when the P6R is receiving a
signal from the transmitter.
Ñ Battery Compartment. Accepts one 9-volt battery
(Duracell recommended). Open the door by
pressing the latches on both sides and pulling.
Ò DIP Switches. Using the DIP Switches, you can
customize the operation of the receiver. See DIP
Switches (below).
Ó Belt Clip. Secures the P6R to a belt, pocket, or to
other clothing.
DIP Switches
DIP
SWITCH
FUNCTION UP DOWN
1 Frequency Select Frequency 1 Frequency 2
2 Stereo/MixMode Select MixMode control stereo control
3 Equalization (Flat/High Boost) Gives a 6 dB boost at 10 kHz
for a better high-end re-
sponse
normal response
4 Limiter defeat Limiter on Limiter off
IMPORTANT: The Limiter is designed to respond to and limit the loudness of
unexpectedly high signals. It is not designed to prevent long term exposure to high SPL
levels. It is designed for use with Shure earphones, so the maximum limited SPL
may be different with other earpieces. We recommend that you always use the built-in
limiter provided with this system. However, a limiter defeat switch has been provided for
those who would prefer to use an external limiter product.
To Next Page
Loading...
