Shure PSM600 - Page 18

13
IMPORTANT!:
THIS RADIO EQUIPMENT IS INTENDED FOR USE IN
MUSICAL PROFESSIONAL ENTERTAINMENT AND
SIMILAR APPLICATIONS.
NOTE: THIS RADIO APPARATUS MAY BE CAPABLE
OF OPERATING ON SOME FREQUENCIES NOT
AUTHORIZED IN YOUR REGION. PLEASE
CONTACT YOUR NATIONAL AUTHORITY TO
OBTAIN INFORMATION ON AUTHORIZED
FREQUENCIES FOR WIRELESS MICROPHONE
PRODUCTS IN YOUR REGION
Licensing: A ministerial license to operate this
equipment may be required in certain areas. Consult
your national authority for possible requirements.
P6T TRANSMITTER
Shure Transmitter Model P6T may be used in the
countries and frequency ranges listed in Table 1 on
page i.
RF Output Power
100 mW (+20 dBm) typical conducted (country
dependent)
Modulation Limiter
Internal peak limiter (>10:1 compression)
Antenna
External whip, 50 Ω BNC connector
Power Requirements
P6T: 100 to 120 Vac, 50/60 Hz
EP6T: 220 to 240 Vac, 50/60 Hz
NOTE: This product is not disconnected from the mains
power supply when the power switch is in the OFF
position.
Current
115 mAac maximum at 120 Vac
55 mAac maximum at 230 Vac
Fuse
P6T: 120 Vac, 160 mA/250 V time delay
EP6T: 230 Vac, 80 mA/250 V time delay
FUSE
Dimensions
44.5 mm X 197.4 mm X 238.1 mm (1
3
/
4
in. X 7
3
/
4
in. X 9
3
/
8
in.)
Net Weight
1.62 kg (3 lbs., 9 oz.)
P6R RECEIVER
RF Sensitivity
1.2 µV typical
Image Rejection
70 dB typical
Spurious Rejection
60 dB typical
Squelch Threshold
4 µV typical
Antenna Input Impedance
50 Ω typical
Antenna
External, threaded connector
Power Requirements
9 V battery
Battery Life
4–6 hours, volume dependent
Audio Output Connector
3.5 mm Stereo (Left = tip, Right = ring, Ground = sleeve)
Minimum Load Impedance
16 Ω
Net Weight
0.52 lbs.
Overall Dimensions
27.18 mm X 64.52 mm X 85.09 mm
(1.070 in. X 2.540 in. X 3.350 in.)
CONNECTORS
P6T Audio Inputs (LEFT/CH.1 and RIGHT/CH.2)
Connector:
(XLR and
1/4-inch
combined)
XLR (female)
1
/
4
-inch
phone jack
(female)
Configuration: electronically
balanced
electronically
balanced
Actual
Impedance:
20 kΩ 20 kΩ
Nominal
Input Level:
+4 dBu
(+4 input level)
–10 dBV
(–10 input level)
+4 dBu
(+4 input level)
–10 dBV
(–10 input level)
Maximum
Input Level:
+25 dBu
(+4 input level)
+13 dBu
(–10 input level)
+25 dBu
(+4 input level)
+13 dBu
(–10 input level)
Pin
Assignments:
Pin 1 = ground
Pin 2 = hot
Pin 3 = cold
Tip = hot
ring = cold
sleeve = ground
Phantom Power
Protection?
Yes
Up to 60 VDC
Yes
Up to 60 VDC
P6T L/R LOOP Outputs (IN and OUT)
Connector:
(XLR and 1/4-inch combined)
1
/
4
-inch
jack (female)
Configuration: electronically
balanced
Actual
Impedance:
20 kΩ
Nominal
Input Level:
+4 dBu
(+4 input level)
–10 dBV
(–10 input level)
Maximum
Input Level:
+25 dBu
(+4 input level)
+13 dBu
(–10 input level)