16 DST4602Evolution User’s Manual
On page S.03 (GEN-SET CONTROL MODULE STATUS), as well as some information on the device (Serial
Number, Date, Firmware installed, Internal code), you can also change the language.
Page S.04 (SERIAL PORTS) is dedicated to serial communication status. In the case of operating errors,
check the information in this page. When using a GSM modem, the phone company and radio signal are also
shown.
Reception COM error counters are displayed. If the condition causing the malfunction has been eliminated,
you can reset the error counters on this page. To activate the error reset function, press the ENTER
button, use the vertical scroll UP and DOWN buttons to select the errors to reset. Hold down the
ACK/TEST + EXIT buttons for a few seconds to display the message “RESET/DEFAULT”. To exit
error selection, use the EXIT button.
To Next Page
Loading...
