Introduction
This document provides an easy reference for installing and operating IDM
Scanners. A complete documentation for IDM Scanner is provided by the
IDM User’s Guide available on the Internet at http://www.sick.com
The document contains a collection of codes that allow you to configure the
IDM hand held readers.Factory default values are marked with a ◆ symbol.
To configure the device scan one or in some cases a sequence of codes. In
some cases you also need to scan option codes contained in the back of this
quick start guide. Depending on the parameter you also need to convert the
values into hex. A hex/ascii table is included in this document. The
programming procedure has to be ended by scanning the “FIN (finish) and/or
“END” code.
Example one scan configuration:
Operation Mode-just scan the code corresponding to the operation mode
required.
Example several codes configuration (without hex/ascii conversion):
Keyboard country-to configure french keyboard country scan “PROGRAMM”
code to enter programming mode. Afterwards scan keyboard country code,
and then scan option code “0” and option code “1”. End this procedure by
scanning the “END” code.
Example several codes configuration (with hex/ascii conversion):
Preamble-to configure a preamble of “PR” scan “PROGRAMM” code, then
preamble code. Afterwards scan option code “5” and option code “0” (50hex
is standing for character P) followed by “5” and “2” (52hex is standing for
character R). Then finish by scanning the “FIN” code. To set back preamble
to none scan “PROGRAMM”, “Preamble”, “FIN” and then “END” code.
SICK makes no warranty of any kind with regard to this publication, including,
but not limited to, the implied warranty of merchantability and fitness for any
particular purpose. SICK shall not be liable for errors contained herein or for
incidental consequential damages in connection with the furnishing,
performance, or use of this publication. This publication contains proprietary
information that is protected by copyright. All rights are reserved. No part of
this publication may be photocopied, reproduced or translated into any
language, in any forms, in an electronic retrieval system or otherwise,
without prior written permission of SICK.
Warranty
The currently released status of SICK General Terms of Delivery Factory
Automation and Logistics Automation shall apply.
Regulatory
1
FCC part 15B
EN55022, EN55024, EN61000-3-2, EN61000-3-3
CNS13438
Industry Canada ICES-003
LED Eye Safety IEC60825-1
RoHS IDM120 and IDM140 are conform to RoHS standards
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20
Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General