SICK IDM120 Series

8015904/YIT8/2015-03-02 © SICK AG · Germany All rights reserved - Subject to change without notice
6
7. DPM functionality
If you own a DPM model (IDMxxx-x2xx) you can enable or disable the DPM code
reading functionality by scanning one of the following barcode commands.
Enable DPM functionality ◆
Disable DPM functionality
In order to verify if the DPM functionality is enabled, please scan the following
barcode. If you can read this barcode, the DPM functionality is enabled.
If you scan „factory default“ the DPM functionality is not disabled.
However please note that if you scan “factory default” and afterwards disconnect the
scanner from your host device, the DPM functionality will be disabled automatically.
If you disable the DPM functionality the performance of reading printed 1D and 2D
codes will be improved.
8. Keyboard Interface Quick Set
To quickly change the record suffix when using keyboard interface (USB or
PS/2) you can use codes below. How the keyboard output string looks like
can be seen below as well. Please note that the other parts of the string, e.g.
pre- or postamble can be configured via the configuration codes in chapter
“Keyboard Interface Control”.
Preamble Data Length Prefix ID Scanned Data
Suffix ID Postamble Record Suffix
1-15 char. 2-4 digits 1 or 3 char. Variable 1 or 3 char. 1-15 char. 1 char.
- Record Suffix -
None
RETURN ◆
TAB
SPACE
ENTER