FIND ME function When this button is clicked, the AUX LED next to the SIG200 POWER voltage
supply connection flashes at a frequency of 1Hz until the button is clicked
again. This function can be used to identify devices that have already been
mounted.
NOTE
If the FIND ME function is active, no further interface navigation can take
place until the STOP button has been clicked in the dialog.
RESTORE FAC‐
TORY SETTINGS
Clicking on this button the SIG200 will reset all settings to the factory
defaults. As a factory default, all ports are configured as digital inputs.
Selection of the RESTORE FACTORY SETTINGS option must be confirmed again
in the Confirm Action field.
If you click Yes, all settings currently stored in the device are overwritten.
After clicking OK, a Success dialog is displayed to confirm the successful
reset of the connected SIG200 to the factory settings.
NOTE
While both of the dialogues boxes are active, no other interface navigation is
possible.
NOTE
The Restore Factory Settings button works from any of the configuration
pages.
HELP The HELP button can be used to access a help page that is displayed on
each parameterization page on the right side of the user interface. Here
you will find additional information about the SIG200 relating to the current
page.
Please use for more detailed information always the operating manual. The
help texts does not include all information from the operating manual.
NOTE
The HELP screen remains open when you switch the parameterization page
via the tree view with parameterization pages.
7 SIG200 CONFIGURATION
16
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8024482.1FJ7 /2022-05-31 | SICK
Subject to change without notice
To Next Page
Loading...
