Table 6: Functions
EDIT The EDIT button allows the settings on a given configuration page to be
changed.
The EDIT button will be highlighted light blue when pressed. Pages that can
be configured will be gray until the EDIT mode is activated.
NOTE
1. Click on the Edit button (top right)
2. Click the RUN button (bottom left).
3. Change the operating mode from RUN to MAINTENANCE.
4. Insert the password "main"
5. Now the device parameterization can be changed.
NOTE
For the sake of device cybersecurity, changing the default password is
strongly recommended.
Process data The process data button provides the process data of the connected IO-Link
devices.
SIG200 CONFIGURATION 7
8024482.1FJ7 /2022-05-31 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
15
Subject to change without notice
To Next Page
Loading...
