Figure 6: CONFIGURATION page, gateway
NOTE
If the Ethernet settings are changed, device communication may be interrupted.
NOTE
A device power cycle is necessary to activate the ethernet parameter changes.
7.2.5.2 IO-Link ports
On the IO-Link Ports tab, settings of the IO-Link ports that can be used in IO-Link or
standard input/output mode can be configured.
An IODD file can be uploaded here for easy parameterization of the connected IO-Link
device. First upload an IODD file using the Upload IODD button. This IODD is then stored
in the SIG200 Repository .
The disk usage shows how much storage capability on SIG200 is available.
After the correct IODD file has been uploaded, it can be assigned to the port to which
the corresponding device is connected (e.g. port S1). To do this, select the IODD file on
the right side of the table using the drop-down menu. All IODDs already in the Repository
are displayed and the correct one can be selected. If an IODD is to be deleted from the
device, select the desired IODD and click DELETE.
After the desired IODD is selected, confirm by clicking the Apply button. The information
from the IODD is now displayed on the IO-Link Devices tab.
NOTE
The upload of one IODD file takes a few minutes. Depending on the size of the specific
IODD file the upload is faster or slower. It is not unusual in case the IODD upload needs
1-5 minutes or longer untill the IODD is fully visualized in the user interface.
7 SIG200 CONFIGURATION
20
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8024482.1FJ7 /2022-05-31 | SICK
Subject to change without notice
To Next Page
Loading...
