Note that the inputs must always be assigned from top to bottom (e.g. for two
inputs A+B and not A+D).
The inputs are outlined in red when connections are made to indicate that a
connection is still required in this area. The two inputs C and D are only active in
the logical truth table if a connection has been made.
NOTE
Green input arrows and green text: a connection is possible
If a connection is not possible, the text will have red color and it is not possible to
drag a connection to the input.
NOTE
Some inputs and logic gates have a small gear indicating that some additional set‐
tings are possible. Clicking on the gear will open the additional settings dialogue
box and allow for additional configuration (e. g. delay time).
3. Clomplete the setup by using the Transfer and Execute Flow button: the new logic
configuration is transfered to the connected SIG200.
NOTE
An error will appear if there are any improper or missing connections. The notifica‐
tion area will indicate a successful transfer.
7.2.7 Settings
The following settings are possible:
Setting Possible values
Language english / german
Figure 10: Settings
The language of the user interface can be selected on the SETTINGS page (German or
English).
Also, if logged in as any user except “Run” (see "User login and editing mode", page 17),
it is possible to change the password for the logged in user.
SIG200 CONFIGURATION 7
8024482.1FJ7 /2022-05-31 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
25
Subject to change without notice
To Next Page
Loading...
