SICK SIG200

7.2.6 LOGIC EDITOR page (logic editor)
Figure 9: LOGIC EDITOR page (logic editor)
The LOGIC EDITOR page of SIG200 allows you to apply user-defined logic functions to the
available input signals and transmit the results to various output signals by dragging
and dropping logic blocks and connection cables.
The left side of the screen lists all configured inputs. The upper middle bar contains the
available logic gates that can be dragged down into the workspace. And listed on the
right side are the configured outputs.
Before setting up any logic, it is required to upload the relevant IODD files. This ensures
that the correct inputs and outputs of every connected IO-Link device are displayed
correctly.
NOTE
Note that the screen is grayed out until you change to editing mode (see "User login and
editing mode", page 17).
Creating a logic system
1. To select the desired logic blocks, click and drag them to the working range.
NOTE
If a logic block has been selected incorrectly, or needs to be removed, click on it
and drag it back up to the selection bar. A garbage bin will appear to remove the
selected logic gate from the workspace.
2. Making connections from the inputs to the logic gates: Click on the desired input,
click again and mark the arrow. A connecting line is then created. Note that you
can drag the line to a desired logic gate input.
As you approach, the logic gate inputs expand to accommodate the connection
cable. As soon as the connection is made, the bends (if there are bends along the
connection), the position of the logic gate and the window size can be adjusted.
The connection is scaled automatically. An incorrect connection can be deleted by
clicking and holding the connecting line. A wastebasket icon is displayed at the top
center of the user interface.
Some logic blocks require at least two input signals.
7 SIG200 CONFIGURATION
24
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8024482.1FJ7 /2022-05-31 | SICK
Subject to change without notice