SICK SiLink2 Master IOLA2US-01101

©SICKAG•PresenceDetection•Subjecttochangewithoutnotice•8017387 11
Operating instructions IO-Link USB Master SiLink2 Master
ElectricalConnection
5 ElectricalConnection
5.1 Safety
IncorrectSupplyVoltage
WARNING!
Devicedamageduetoincorrectsupplyvoltage!
Incorrectsupplyvoltagecancausedamagetothedevice.
Therefore:
• Ifnecessary,onlyoperatetheSiLink2Masterusingthe
suppliedwallplug.
5.2 ElectricalConnectionofSiLink2Master
2
USB IO-Link
PC SiLink2 Master IO-Link Device
1
Fig. 3: Electrical Connection of SiLink2 Master
1 USB cable
2 Sensor cable
1. Ensurepowersupplyisnotconnected.
2. ConnectthePCtotheUSBMiniBfemaleconnectoroftheSiLink2
MasterusingthesuppliedUSBcable.
3. ConnectIO-LinkdevicetotheM12maleconnectoroftheSiLinkMaster
usingasensorcable.A3-poleor4-polecablemaybeusedasthe
sensorcable.
NOTE!
If the power requirement of the IO-Link device is
> 80 mA, connect the supplied wall plug to the DC 24 V
female connector of the SiLink Master and connect the
wall plug to the supply voltage.