Instructions to action
►
The arrow denotes instructions to action.
1. The sequence of instructions is numbered.
2. Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
2 Safety information
2.1 General safety notes
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
Machinery Directive.
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
Figure 1: Laser class 1
This device complies with the following standards:
•
EN/IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
This laser product corresponds to laser class 1 after having been assessed on
the basis of the Low Voltage Directive 2014/35/EU, which applies to all manufac‐
turers placing products on the market, in conjunction with EN/IEC 60825-1:2014
in the currently applicable version. Due to the differing statutory requirements on
occupational safety according to guideline 2006/25/EC, this product has to be
assessed based on the older standard EN 60825-1:2007. According to the older
standard EN 60825-1:2007, this product is partially classified in laser class 2 and is
considered safe when used as intended.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
OPERATING INSTRUCTIONS
40
O P E R A T I N G I N S T R U C T I O N S | WTM10L 9382969/2024-02-23 | SICK
Subject to change without notice
en
To Next Page
Loading...
