6.4.4 Output configuration
Tap the desired operating mode. Repeat this process for each output as needed.
Figure 22: Display output function navigation
6.4.5 Restoring to factory default settings
The sensor offers the function to restore the factory default settings.
Figure 23: Factory configurations
6.4.6 Configuration via IO-Link
In addition to manual setting the parameters on the device, the sensor can also be
configured via IO-Link.
Configuration via IO-Link can be performed in two ways:
•
Configuration via the SiLink box (required software: SOPAS ET from SICK)
To do this, connect the sensor to a computer via USB using the SiLink box.
•
Configuration via an IO-Link Master (PLC), e.g. SIG350
You can quickly and easily test and parameterize the connected products using the
SOPAS ET program (SICK Engineering Tool with graphic user navigation and convenient
visualization).
Details on configuration can be found in the detailed IO-Link description: Technical
Information: Photoelectric sensors, SICK Smart Sensors / IO-Link.
7 Troubleshooting
The Troubleshooting table indicates measures to be taken if the sensor stops working.
OPERATING INSTRUCTIONS
60
O P E R A T I N G I N S T R U C T I O N S | WTM10L 9382969/2024-02-23 | SICK
Subject to change without notice
en
To Next Page
Loading...
