SICK WTM10L - Notes on Electrical Installation

Figure 6: Alignment of the sensor relative to the object direction
Note the preferred direction of the object relative to the sensor, cf. figure 6 / Dimen‐
sional drawings.
Mounting with the foreground suppression principle of operation
Figure 7: Alignment of the sensor
Note the preferred direction of the object relative to the sensor, cf. figure 7.
Tightening torque
Note the sensor’s maximum permissible tightening torque of < 0.56Nm.
5 Electrical installation
5.1 Notes on electrical installation
NOTICE
Equipment damage due to incorrect supply voltage!
An incorrect supply voltage may result in damage to the equipment.
■
Only operate the device with safety/protective extra-low voltage (SELV/PELV).
■
The sensor is a device of protection class III.
■
Only operate the device with an LPS (limited power source) in accordance with
IEC62368-1 or an NEC Class 2 power supply unit.
OPERATING INSTRUCTIONS
46
O P E R A T I N G I N S T R U C T I O N S | WTM10L 9382969/2024-02-23 | SICK
Subject to change without notice
en