Sicma S.p.A.
Miglianico (CH)
page 10
IDENTIFICATION PLATES
Identification plates are placed on every shredder and are structured as follows:
model of shredder
(example)
dimension
(example)
P.T.O. information
(example)
When asking for information or technical service, always
specify the machine type and width.
ALLOWED USE
SICMA shredders, as described in this instruction and maintenance booklet, have been specifically
designed to mince grass, shrubs and wood up to 6 – 7 cm diameter
Any other use jeopardizes the operator’s safety and the machine integrity.
IMPROPER USE
When using SICMA shredders it is particularly forbidden:
- The attachment to vehicles of unsuitable power or weight.
- To assemble the machine without securing the rebound tie rods of the three-point hitch of
the tractor’s elevator.
- To work in excessively stony grounds
- To use the machine without inserting the check-pins when supplied.
- To work in excessive slopes.
- To lift the machine when the power takeoff is engaged.
- To approach the machine when wearing inappropriate work clothing.
To get on the machine while it is being used or transported
To Next Page
Loading...
