Sicma S.p.A.
Miglianico (CH)
page 23
STARTING UP
Now that all setting up operations are completed, your machine is ready to be used; after reaching
the work place we advice to engage power takeoff only after having lifted the shredder of a few
centimetres with the tractor elevator. After this, it is possible to start engine, engage power takeoff,
drop the machine down to work position and start using it.
WORKING SPEED
The working speed depends on the quality, the diameter and the height of the material to be cut;
anyway, it must be between 3 and 10 km/h. The power takeoff speed must be 540 rpm maximum
(max 1000 rpm FB shredder)
ROAD TRANSPORT
While transporting the machine it is very important to follow the road traffic code of the country
where you circulate.
SET ASIDE
If your shredder will not be used for a long period of time, we advice to:
1 Wash the machine accurately and dry it.
2 Check out all equipment and replace eventual damaged or worn parts.
3 Tighten strongly all bolts and nuts (ref. bolts and nuts tightening table).
Make an accurate greasing and finally protect the whole machine with a tarpaulin and put it in a dry
place.
To Next Page
Loading...
