Sicma S.p.A.
Miglianico (CH)
page 20
SIDE SKIDS ADJUSTMENT
The side skids whom some shredder models (TLX-R, TS, TS-P, TRX, TR, TUF, TRP, FB, SL,
TMX, TE) are provided with, avoid an excessive sinking of the machine on the ground during
working.
To adjust the skids height (picture 14):
- Unscrew and extract screws A.
- Adjust the skids height through holes B
up to needed height.
- After regulation insert back and tighten
screws A strongly (refer to the bolt and
nuts tightening table described on this
booklet).
Do the same thing on the opposite side of the
machine.
Picture
14
These operations shall be made only on working ground and
only after having stopped the engine, disengaged the power
takeoff and pulled the parking brake. If necessary, lift the
machine from the ground but, in order to avoid risks for
people, place it on rests thus preventing any injuries that
might be caused by its sudden fall.
WOOD CUTTING
Some shredders models (TMX, SL, TS, TS-P, TRX, TR, TUF, and TE), provided with hammers
(see “cutters” section) and with back blades, are able to mince also bigger shrubs.
To place the back blades (picture 15):
- Insert the back blades A into their special
housing;
- Push them up to make them skimming the soil;
- Insert split pin B into the special drilling up to
needed height.
Picture
To Next Page
Loading...
