Servicing
Standard machines_Operating_Instructions_Compact
16 56100000002001 EN, 01/2010
CAUTION
If the machine is to be out of service for a period in excess of 12 months, you must
take suitable anti-corrosion, mothballing, packaging, and drying measures.
Switching on the anti-condensation heater
If an anti-condensation heater is provided, switch it on during the machine
stoppages.
Taking the machine out of service
For details of measures that need to be implemented, please refer to Section
Application planning (Page 4).
L
ubricating before recommissioning
CAUTION
The machine must be relubricated during commissioning if it has been out of
service for more than 1 year, in order to ensure that the grease is distributed
throughout the bearings. The shaft must rotate for the grease to be distributed.
Please observe the information on the lubricant plate if carrying out relubrication
using relubrication equipment.
e also the section titled "ApplicationSe planning - Bearing lifetime".
Servicing
WARNING
Safety instructions
● Before starting work on the machines, make sure that the plant or
system has been disconnected in a manner that is compliant with
the appropriate specifications and regulations.
● In addition to the main currents, make sure that supplementary and
auxiliary circuits, particularly i
disconnected.
n heating devices, are also
ch temperatures above 50 °C.
lt in burn injuries!
personal protective gear such as gloves, goggles, face masks,
nings provided in the relevant safety data sheet.
Chemical agents must be compatible with the machine's
components, especially if these contain plastics.
● Certain parts of the machine may rea
Physical contact with the machine could resu
Check the temperature of parts before touching them.
● When carrying out cleaning using compressed air, make sure that
appropriate methods of extracting fumes are in place and that
or similar are worn.
● If you are using chemical cleaning agents, observe the instructions
and any war
To Next Page
Loading...
