Siemens 3AH User Manual (English)

Other manuals for Siemens 3AH

Instructions, Installation, Operation, Maintenance33 pages

Questions and Answers:

O
owenstabithaJul 28, 2025
What to do if my Siemens 3AH circuit breaker will not trip?
- E
  Elizabeth HarperJul 28, 2025
  If your Siemens Other circuit breaker won't trip, several factors could be at play. First, check if the secondary control power is de-energized or if the control power fuses are blown and correct as indicated. Inspect for any damage to wiring, terminals, or connectors, and repair as necessary. Also, verify that there is a tripping signal to secondary disconnect contact 1, check for continuity, and correct the relay logic. Ensure that secondary disconnect contacts 1 or 2 are engaging properly, and replace them if required. Check the trip coil (52T) for failure, and replace it if necessary. Finally, confirm that auxiliary switch NO contacts 23-24 or 33-34 are not open when the breaker is closed; check the linkage and switch, and replace or adjust as needed.
D
David BentleyAug 3, 2025
What causes a Siemens Other breaker to fail to close?
- L
  lunadanielAug 3, 2025
  Several issues can cause a Siemens Other breaker to fail to close. The secondary control circuit might be de-energized, or the control circuit fuses could be blown; check and energize or replace if necessary. The secondary disconnect contacts 15 or 16 might not be engaging, so check and replace if required. Damage to wiring, terminals, or connectors could also be the cause; check and repair as necessary. A failure of the charging motor (88) or the motor cut-off switch LS21 or LS22 failing to operate can also prevent the breaker from closing, so replace if required. For a mechanical failure of operating mechanism, it is recommended to refer to factory or authorized service shop.
F
Felicia BrownAug 12, 2025
What causes nuisance or false trips in Siemens 3AH Other?
- D
  deborahmorrisAug 12, 2025
  Nuisance or false trips in Siemens Other can stem from electrical or mechanical issues. If the tripping signal remains energized on secondary disconnect contact 1, check for improper relay logic. In the case of a mechanical problem, it could be due to a mechanical failure of the operating mechanism. Check and contact factory or authorized service shop.
H
Hannah SchultzAug 19, 2025
What to do if there is nuisance or false close in Siemens 3AH Other?
- D
  Dr. Charlene MullenAug 19, 2025
  Nuisance or false closing in Siemens Other can be due to electrical or mechanical problems. For electrical issues, check for a nuisance or false closing signal to secondary disconnect contact 13, check the relay logic and correct as required. If the issue is mechanical, there may be a mechanical failure of operating mechanism. In this case, check and contact factory or authorized service shop.