Maintenance
9229 9992 176 0D 59
2013-07-08
Manufacturer's product liability
The manufacturer's product liability shall be excluded if at least one of the following
criteria applies:
• Original Siemens spare parts are not used.
• Fitters carrying out replacements have not been trained and certified by
Siemens.
• Parts have been incorrectly fitted or adjusted.
• Adjustments are not made in accordance with Siemens specifications.
• After installation and adjustment, no final test is performed with a tester
approved by Siemens including documentation of the test results.
To keep documentation complete, it is important that measurement results are
submitted to the responsible Siemens representative.
Disposal
The materials of the vacuum circuit-breaker should be recycled. Disposal of the
vacuum circuit-breakers with minimum environmental impact is possible on the
basis of existing legal regulations.
Metal The circuit breaker's metal components can be recycled as mixed scrap, although
wide-ranging dismantling into sorted scrap and mixed scrap residues is more
environmentally sustainable.
Electronics Electronic scrap must be disposed of in accordance with applicable regulations.
Materials The vacuum circuit-breaker consists of the following materials:
• Steel (partly phosphatised, galvanised and yellow chromated)
• Copper (partly silver-plated)
• Plastics (epoxy resin, polyamide, polyester, polycarbonate, ABS-PC mixture;
partly glass fibre reinforced)
• Rubber materials
•Ceramics
•Lubricant
Packaging If the packaging is no longer needed, it can be fully recycled.
Hazardous substances When delivered by Siemens, the product does not contain any hazardous substances
within the scope of the hazardous substances regulations applicable to the territory of
the Federal Republic of Germany. For operation outside the Federal Republic of
Germany, the applicable local laws and regulations must be complied with.
Further information Contact your Siemens Service Center if you require further information.
Service
For details of contacts for service work, consult Siemens IC LMV SE Services at
• Telephone: +49 180/5247000
• Fax: +49 180/5242471 or
• on the Internet at the Web address: www.siemens.com/energy-support
• by e-mail: support.energy@siemens.com
• or any local Siemens office.
To Next Page
Loading...
