Transport, storage and packing
6 9229 9992 176 0D
2013-07-08
Transporting with packing Transport the transport unit to the installation site or storage location
• with a fork lift or
• with sling gear suspended from a crane
- at an angle of twist of approx. 60° or
- with a spreader bar.
After receipt of delivery:
Checking
the transport unit
• Check transport unit for damage;
• Major damage must be documented photographically.
• Ensure that any damage to the transport unit is confirmed by the transport
company.
Unpacking (I)
Working equipment Required tools:
- Knife/scissors
- Lifting equipment with lifting gear
- Pliers or lever
Note
Some of the images in this section show a different circuit-breaker type. These
images are exemplary and also apply to the vacuum circuit-breaker 3AH37/38.
CAUTION
Risk of injury from sharp edges!
Fasteners may break, leaving sharp edges.
Always use a suitable tool to lever out fasteners.
Note
Do not cut open or damage the carton, since it is designed to be reused and
because of the belt straps located underneath.
Belt straps could be severed on the pallet floor when cutting open the carton.
The vacuum circuit-breaker is attached to the pallet with belt straps. It is not
permissible to transport the vacuum circuit-breaker on the pallet without using
belt straps (see Fig. 5).
To Next Page
Loading...
