Transport, storage and packing
9229 9992 176 0D 13
2013-07-08
Unpacking (III)
Working equipment Required tools:
- Screwdriver
- Knife/scissors
- Lifting equipment with lifting gear.
Opening the transport unit • Place the transport unit on a level, non-slip and pressure-resistant surface.
• Remove lifting gear or transport means.
• Unscrew all the screws from the cover and lift it off.
• Take out the partitions and check for damage.
Note
Some of the images in this section show a different circuit-breaker type. These
images are exemplary and also apply to the vacuum circuit-breaker 3AH37/38.
Note
Do not use the vacuum circuit-breaker if parts are broken, i.e. if you find cracks,
flakings, bent metal parts, damaged plug-in contacts, tears or bare cables.
Send it back in its original transport unit (see “Reusing the transport unit”,
page 16).
Fig. 14 Removing the cover Fig. 15 Taking out the partitions
To Next Page
Loading...
