Siemens 3AK1 - Fitting the vacuum circuit-breaker module

Mounting
38 9229 9923 176 0B
2013-09-09
Fitting the vacuum circuit-breaker module
• Lift the withdrawable section unlocking lever (95.). This draws in the laterally
projecting locking pins (93.).
• Fit the vacuum circuit-breaker module into the system's guide rails and push in
as far as it will go.
• Fully fold the withdrawable section unlocking lever (95.) back down. The locking
pins (93.) now secure the vacuum circuit-breaker module in the switchgear.
Fig. 45 Fitting the vacuum circuit-breaker module Fig. 46 Locking the vacuum circuit-breaker module