$SSHQGL[6$
9
&* &
¿©©©©§©©©©©©©©©©©©©§©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©§©©§©©§©§©©©¤
FNo.Abbreviation Meaning OpFtEIOT
¨©©©©ª©©©©©©©©©©©©©ª©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©ª©©ª©©ª©ª©©©
2141Emer.Gen.TripEmerg. O/C protection: General Trip OT
2142Emer.Trip1pL1Emerg. O/C protection: Trip 1pole L1 COT
2143Emer.Trip1pL2Emerg. O/C protection: Trip 1pole L2 COT
2144Emer.Trip1pL3Emerg. O/C protection: Trip 1pole L3 COT
2145Emer.Trip 3p Emerg. O/C protection: Trip 3pole COT
2303>Backup block>Block back-up overcurrent time prot. CG IOT
2403Backup activeBack-up overcurrent prot. is active OT
2405Backup E off Back-up earth O/C is switched off CG OT
2406Backup Ph offBack-up phase O/C is switched off CG OT
2411Back Gen. FltBack-up overcurrent: Gen. fault det. G OT
2412Backup Flt L1Back-up overcurrent: Fault detection L1 COT
2413Backup Flt L2Back-up overcurrent: Fault detection L2 COT
2414Backup Flt L3Back-up overcurrent: Fault detection L3 COT
2415Backup Flt E Back-up earth fault detection , E COT
2421Backup I>> Back-up overcurrent: Fault det. I>> COT
2422Backup I>/Ip Back-up overcurrent: Fault det. I>/Ip COT
2425Backup IE>> Back-up earth fault det. highset IE>> COT
2426Back IE>/IEp Back-up earth fault detection IE>/IEp COT
2441Backup TI>> Back-up overcurrent: Time TI>> expired OT
2442Backup TI>/TpBack-up overcurrent: Time TI>/Tp exp.OT
2445Back TIE>> Back-up overcurrent: Time TIE>> exp. OT
2446Back TIE>/TEpBack-up overcurrent: Time TIE>/TEp exp. OT
2451Back Gen.TripBack-up overcurrent: General trip OT
2452Back Trip L1 Back-up overcurrent: Trip 1pole L1 COT
2453Back Trip L2 Back-up overcurrent: Trip 1pole L2 COT
2454Back Trip L3 Back-up overcurrent: Trip 1pole L3 COT
2455Back Trip 3p Back-up overcurrent: Trip 3pole COT
2701>AR on >AR: Switch on auto-reclose function IOT
2702>AR off >AR: Switch off auto-reclose functionIOT
2703>AR block >AR: Block auto-reclose function CG IOT
2704>AR reset >AR: Reset auto-reclose function C IOT
2706>1p RAR block>AR: Block 1pole rapid auto-reclose CG IOT
2707>3p RAR block>AR: Block 3pole rapid auto-reclose CG IOT
2708>RAR block >AR: Block rapid auto-reclose CG IOT
2709>DAR block >AR: Block delayed auto-reclose CG IOT
2711>Start AR >AR: External start for internal AR C IOT
2712>Trip L1 AR >AR: Ext. Trip L1 for internal AR C IOT
2713>Trip L2 AR >AR: Ext. Trip L2 for internal AR C IOT
2714>Trip L3 AR >AR: Ext. Trip L3 for internal AR C IOT
2715>Trip 1p AR >AR: Ext. 1pole trip for internal AR C IOT
2716>Trip 3p AR >AR: Ext. 3pole trip for internal AR C IOT
2721>DAR aft. RAR>AR: Delayed AR only after rapid AR CG IOT
2730>CB ready >AR: Circuit breaker ready for reclose IOT
2731>Sync.release>AR: Synchronism from ext. sync.-check IOT
2781AR off AR: Auto-reclose is switched off CG OT
2782AR on AR: Auto-reclose is switched on OT
2783AR inoperativAR: Auto-reclose is blocked CG OT
2784AR not ready AR: Auto-reclose is not ready OT
2785AR block.dyn.AR: Auto-reclose is dynamically blocked COT
2787CB not ready AR: Circuit breaker not ready OT
2788AR T-CB Exp. AR: CB supervision time expired OT
2801AR in prog. AR: Auto-reclose in progress COT
2811RAR only AR: Only rapid auto-reclosing allowedOT
2812RAR T-act.runAR: Action time for RAR is running OT
2813RAR T-1p run.AR: 1pole dead time for RAR is running COT
2814RAR T-3p run.AR: 3pole dead time for RAR is running COT
2815RAR 1p Prog. AR: 1pole rapid auto-reclose program OT
2816RAR 3p Prog. AR: 3pole rapid auto-reclose program OT
¥©©©©¦©©©©©©©©©©©©©¦©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©©¦©©¦©©¦©¦©©©¾