7SR242 Duobias Commissioning & Maintenance Guide
The copyright and other intellectual property rights in this document, and in any model or article produced from it
(and including any registered or unregistered design rights) are the property of Siemens Protection Devices
Limited. No part of this document shall be reproduced or modified or stored in another form, in any data retrieval
system, without the permission of Siemens Protection Devices Limited, nor shall any model or article be
reproduced from this document unless Siemens Protection Devices Limited consent.
While the information and guidance given in this document is believed to be correct, no liability shall be accepted
for any loss or damage caused by any error or omission, whether such error or omission is the result of
negligence or any other cause. Any and all such liability is disclaimed.
©2010 Siemens Protection Devices Limited
7SR242 Duobias
Multi-Function 2-Winding Transformer Protection Relay
Document Release History
This document is issue 2010/02. The list of revisions up to and including this issue is:
2010/06 Defect Report Form revised
2010/02 Document reformat due to rebrand
2010/02 Third issue. Software revision 2662H80001 R4c-3
2008/07 Second issue. Software revision 2662H80001R3d-2c.
2008/05 First issue
Software Revision History
2010/02 2662H80001 R4c-3 Revisions to: VT ratio settings, 87BD 1
st
bias slope limit setting
increments, CB fail function, LED CONFIG menu, DATA STORAGE
menu.
Added: Open circuit detection (46BC), CONTROL MODE menu,
Close circuit supervision (74CCS), Measured earth fault undercurrent
(37G), Pulsed output contacts.
2008/07 2662H80001R3d-2c. Demand metering. Optional DNP3.0 data comms.
2008/05 2662H80001R3-2b First Release
To Next Page
General
