To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIPROTEC 7ST61 and is the answer not in the manual?
General| Rated system voltages | Up to 36 kV |
|---|---|
| Rated Current | 1 A or 5 A |
| Rated frequency | 50/60 Hz |
| Binary outputs | Up to 8 |
| Current inputs | 3 |
| Voltage inputs | 3 |
| Display Type | LCD |
| Current Input | 1 A or 5 A |
| Communication Protocols | IEC 61850 |
| Mounting Type | Panel Mount |
| Protection Functions | Overcurrent, Earth Fault |
| Weight | 1.5 kg |
| Operating Temperature | -25 °C to +55 °C |
Configuration of slave address, PNO ID, baud rate, and time synchronization settings.
Settings for operating mode, redundancy, and network size for fibre-optical interfaces.
Details on command output modes for switching operations using PROFIBUS-DP.
How the device reacts to communication interruptions and reestablishment.
Functionality and requirements for event list recording via PROFIBUS-DP.
Selecting PROFIBUS-DP interface and mapping files for device configuration.
Preconditions and steps for interface and mapping selection in DIGSI 4.21.
Steps for interface and mapping selection in DIGSI versions 4.3 and above.
Using the DIGSI Configuration Matrix to route data to the system interface.
Procedure for converting measured values (type, factor, offset) for PROFIBUS-DP.
Enabling and configuring time sync messages via PROFIBUS System Management.
Accessing PROFIBUS-DP data using system functions SFC14 and SFC15 in STEP7.
