Siemens SIPROTEC 7SJ64 - User Manual

Revision 4.2
Edition: April 2005
C53000-L1840-B001-03
SIPROTEC
Protection devices
7SA522, 7SA6
7SD5, 7SD610
7SJ61...7SJ64
7ST622, 7ST61, 7ST63
7UM61, 7UM62
7UT612, 7UT613, 7UT63
7VE61, 7VE63
7VK61
Input/Output unit
6MD63
Bay control unit
6MD663/6MD664
Communication module
PROFIBUS-DP
Communication profile
Preface
Table of contents
PROFIBUS Communication modules 1
Parameters and properties 2
Data type definitions 3
PROFIBUS-DP - Parameterization in DIGSI 4
Technical data 5
Index

Siemens SIPROTEC 7SJ64 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ64
Category	Protection Device
Language	English

Summary

Hazardous Voltages Warning

Qualified Personnel Requirements

Defines qualifications for personnel working with the equipment, emphasizing safety and training.

Chapter 1: PROFIBUS Communication modules

1.1.3 Compatibility of Communication Module Hardware with Firmware

1.2.1 Block 1: Status and Parameters of PROFIBUS-DP Slave

Chapter 2: Parameters and Properties

2.1 Bus Specific Parameters

Defines bus-specific parameters for PROFIBUS-DP communication between master and slave.

2.2 Execution of Switching Operations

Details the execution of switching operations and command output modes via PROFIBUS-DP.

2.3 Response to Disturbed Communication

Describes device behavior during communication interruptions and line-breaks.

2.5 Event List via PROFIBUS-DP

Covers the function and handling of the event list via PROFIBUS-DP.

2.1.1 PROFIBUS-DP Settings

2.1.2 Fibre-Optical Interface Configuration

2.2.1 Command Output Modes

2.2.2 Transformer Tap Change Commands

2.3.1 Communication Interruption

2.3.2 Signalling of Line-Breaks in Fibre-Optical Ring

2.5 Event List via PROFIBUS-DP

2.5.1 Event List Properties

Chapter 4: PROFIBUS-DP Parameterization in DIGSI

4.1 Interface Selection and Mapping Files

Covers selecting the PROFIBUS-DP interface and mapping files in DIGSI.

4.2 Allocation Customization

Explains how to customize data allocations for the system interface.

4.3 Scaling of Measured Values

Details the process of scaling measured values for PROFIBUS-DP transmission.

4.4 Time Synchronization

Describes time synchronization setup and parameterization via PROFIBUS.

4.5 Using SFC14 and SFC15 in STEP7

4.1.1 Standard Mappings 3-1 to 3-n

4.1.3 DIGSI 4.21 Interface and Mapping

4.1.4 DIGSI 4.3+ Interface and Mapping

4.2 Allocation Customization

Source System Interface

Destination System Interface

Adding an Allocation

4.3.1 Measurement Conversion

4.3.2 Number Representation

4.3.3 Parameterization in DIGSI

4.4.1 PROFIBUS-DP Master

4.4.2 Parameterization in DIGSI

Peripheral I;O Access Commands

SFC14, SFC15 and Consistent Data

Universal Module

Chapter 5: Technical Data

5.1 Connection via PSE Module

5.2 Connection via PSO Module

PSE Module Connection Details

Bus Termination and OLM (PSE)

PSO Module Connection Details

PSO Module Optical Network Settings