To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIPROTEC 7VE61 and is the answer not in the manual?
General| Product Type | Protection relay |
|---|---|
| Current Input | 1 A or 5 A |
| Voltage Inputs | 4 |
| Number of Measuring Inputs | Up to 12 |
| Communication Interfaces | Ethernet, RS485 |
| Operating Temperature | -25°C to +55°C |
| Storage Temperature | -40°C to +70°C |
| Frequency | 50 Hz, 60 Hz |
| Binary Outputs | Up to 16 |
| Communication Protocols | IEC 61850, IEC 60870-5-103 |
| Mounting | Rack mounting |
| Display | LCD |
| Protection Functions | Overcurrent, Earth fault, Overvoltage, Undervoltage, Frequency |
| Standards | IEC 60255, IEEE C37.90 |
| Housing | Metal |
| Voltage Range | 80 to 120% of rated voltage |
Details on available PROFIBUS communication module types and their hardware revisions.
How to access and interpret module-specific information displayed on the SIPROTEC device.
Defines PROFIBUS-DP settings like slave address and PNO identification number.
Settings for operating mode, redundancy, and network size for fibre-optical connections.
Configures event list entries and defines PROFIBUS-DP data for master parameterization.
Details on executing switching operations and handling communication interruptions.
Defines single-point, single command, double-point, and double command data types.
Specifies data formats for measured values (signed integer, float) and metered measurands.
Defines data types for transformer tap commands and message blocks for event lists.
Guides on selecting PROFIBUS-DP interface and appropriate mapping files in DIGSI.
Methods for customizing data object routing and scaling of measured values in DIGSI.
Details on time synchronization setup and using SFC14/SFC15 with STEP7.
Technical data for PROFIBUS connection via the PSE module (RS485 interface).
Technical data for PROFIBUS connection via the PSO module (fibre-optical interface).
