7SG12 DAD N Installation
1 Unpacking, Storage & Handling
On receipt, remove the relay from the carton and inspect it for obvious damage. It is recommended that the
relay modules are not removed from the case. To prevent the possible ingress of dirt, the sealed polythene
bag should not be opened until the relay is to be used.
If damage has been sustained a claim should immediately be made against the carrier, also inform Reyrolle
Protection and the nearest Reyrolle agent.
When not required for immediate use, the relay should be returned to its original carton and stored in a clean,
dry place.
The relay contains static sensitive devices, these devices are susceptible to damage due to static discharge
and for this reason it is essential that the correct handling procedure is followed.
The relay’s electronic circuits are protected from damage by static discharge when the relay is housed in its
case. When individual modules are withdrawn from the case, static handling procedures should be observed.
• Before removing the module from its case the operator must first ensure that he is at the same potential as
the relay by touching the case.
• The module must not be handled by any of the module terminals on the rear of the chassis.
• Modules must be packed for transport in an anti-static container.
• Ensure that anyone else handling the modules is at the same potential.
As there are no user serviceable parts in any module, there should be no requirement to remove any
component parts.
If any component parts have been removed or tampered with, then the guarantee will be invalidated. Reyrolle
Protection reserves the right to charge for any subsequent repairs.
2 Recommended Mounting Position
The relay uses a liquid display (LCD) which is used in programming and or operation. The LCD has a viewing
angle of ± 45º and is back lit. However, the best viewing position is at eye level, and this is particularly
important when using the built-in instrumentation features.
The relay should be mounted to allow the operator the best access to the relay functions.
3 Relay Dimensions
The relay is supplied in an Epsilon case E8.
4 Fixings
4.1 Crimps
4mm Ring crimp terminals suitable for the appropriate wire gauge are recommended.
4.2 Panel Fixing Screws
2-Kits – 2995G10046 each comprising:
• Screw M4 X10
2106F14010 – 4 off
• Lock Washes
2104F70040 – 4 off
©2010 Siemens Protection Devices Limited Chapter 6 Page 3 of 4
To Next Page
Loading...
