Troubleshooting en
67
Fault Cause and troubleshooting
Display shows "Re-
start appliance".
Appliance has a fault.
1. Set the mains switch to and wait 60seconds.
2. Set the mains switch to .
Display shows
calc'nClean very fre-
quently.
Decalcified water still contains small amounts of lime.
1. Insert a new water filter.
2. Set the corresponding water hardness.
Incorrect or too little descaling agent used.
▶ When descaling, only use suitable tablets.
Service programme has not been carried out in its en-
tirety.
▶ Start the "Special rinsing step /" service pro-
gramme.
→"Service programmes", Page61
To Next Page
Loading...
