Need help?Do you have a question about the Siemens 9510 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | 9510 |
| Category | Measuring Instruments |
| Language | English |
Instructions for connecting the ground terminal to a proper earth ground using specified wire gauge.
Details on wiring mechanical relays (R1-R3) for digital outputs, including specifications.
Details on wiring solid state relays (D1-D4) for digital outputs, including specifications.
Wiring and specifications for standard digital inputs S1 through S8.
Wiring and specifications for meter ordering option digital inputs DI1 through DI8.
Specifications and wiring for analog inputs AI1 through AI4, including input impedance and accuracy.
Specifications and wiring for analog outputs AO1 through AO4, including driving capability and latency.
Specifications for voltage inputs, including connector type, wire gauge, and dielectric withstand.
Specifications for connecting standard and low voltage DC power supplies to the meter.
Procedure for powering up the meter after ensuring ground connection and correct voltage.
Overview of setup screens available via the front panel for meter configuration.
Configuration settings for COM ports, including protocol, baud rate, transmit delay, and unit ID.
Configuration settings for IP address, subnet mask, gateway, and DNS servers.
Settings for swell/sag limits, nominal voltage, event priority, and digit grouping.
Instructions for verifying meter operation using front panel LEDs and understanding their meaning.
To Next Page