Siemens A30853 - Handset and Loudspeaker Volume; Call Processing Type

Programming the telephone settings
30
kap01.fm5
27.11.98
Profiset 30isdn engl.: A30853-X300-B107-1-7619
Handset and loudspeaker volume
You can set the volume of the handset and loudspeaker to
four levels (1...4: 1=minimum volume, 4=maximum vol-
ume). The volume is preset to level 2. You can set the vol-
ume via the digit keys or the +/- keys.
In the course of a call, you can change the volume via the
+/- key. The setting applys only to the current call.
Call processing type
The following settings are possible:
● 0 = Main station: If you were assigned MSNs by your
network operator, this is the correct call processing
type. Several devices with the same or different MSN
can be connected to a main station, whereby calls be-
tween these devices are liable for charges. “Main sta-
tion“ is also the correct call processing type for oper-
ating at the majority of extensions (PBX).
● 1 = Point to point: Point to point connection =
system operation. In the event of a telephone system
failure, the telephone can be operated at a system
connection. In this emergency operation scenario, the
simple telephone functions can be activated. The
telephone rings with every incoming call at the sys-
tem connection irrespective of possibly entered
MSN.
The telephone is preset to “Main station“.
a
Handset is on-hook.
S23
Start the programming procedure.
1 ... 4
Press one of the keys 1 ... 4.
or
+ / -
Change the volume step by step via the +/- key.
S
Save the setting.
a
Handset is on-hook.
S06
Start the programming procedure.
T
Enter the password if necessary.
0 or 1
Press key 0 or 1 .
S
Save the setting.