Siemens A35 - Text Messages (SMS); Reading New and Existing Messages

V1.0 Page 17 of 38 ICM MP CC ST
A35-A36-A40 Company Confidential 09/01
5. Power Supply
5.1 Overview and Voltages Notes
The following restrictions must be considered:
• The phone cannot be operated without battery.
• The phone will be damaged if the battery is inserted the wrong way round
(the mechanics of the phone prevent the battery from being put in the
wrong way round). The electric system assumes that the battery as been
inserted correctly.
Voltages overview
SV Funk
Radio PartLOGIK
EGOLD+
FLASH
AMD
8Mbit
AMD
16Mbit
Intel
8Mbit
Intel
16Mbit
ST
8Mbit
ST
16Mbit
DISPLAY
SIM
LED
Vibra
I / O
I / O I / O I / O I / O I / O I / O
I / O
I / O
SV Logik
SV-ASIC
2 Volt
2.65 Volt Reg.
2.9 Volt
BATT+
RTC
PA
2.8 Volt Reg.1
PA-Regelung
TXVCO
SMARTI
13 MHz
2.8 Volt Regl.2
2 Volt (RTC)
Ri
Linear-
regulator
[ASIC]
Linear-
[ASIC]
1,6 A
TX
110 mA max.
2,9V +-2%
2,65V +-3%
140mA max.
220mA max.
2,8V +- 3,5%
2,8V +- 3,5%
75 mA max.
45 mA max.
EGOLD+ Core
Flash
Display
Illumination, Display
+ Keypad, Vibra (optional)
Flash 2) + SIM
EGOLD+ Portpin
RX, TX
RF Synth / VCXO
NiMH 600mAh
PA
+Control
Linear-
regulator
[ASIC]
2,07V +-3%
VDDRTC
Linear-
regulator
[ASIC]
2,0V +-5%
100mA max.
10mA max.
EGOLD+ Ringing
(16Ohm HK+GAIM)
193mA + 20mA.
55mA+6mA
22 µF
(at PA)
Display
20mA max.
1mA max.
2) Intel 55mA max.
ST 20mA max.
100mA max.
100mA max.
regulator
Linear-
N430
regulator
Linear-
N431
regulator