V1.0 Page 36 of 38 ICM MP CC ST
A35-A36-A40 Company Confidential 09/01
8.3 SIM-Card- and Display Connector
The SIM-CARD is supplied at pin2 with CCVCC. To get CCVCC (2,9V) the Notes
ASIC D200 pin12 is used to switch 2,9V pin 14 to pin 13with the EGOLD+(SIM L18)
signal CCVZQ. If no SIM-CARD is connected the EGOLD+ tries 3 times to connect
the SIM-CARD. After this time the EGOLD+ stops trying.
That means, if the EGOLD+ is losing the connection while normal operation of the
mobile phone, the mobile must be switched off and on again.
The communication between the EGOLD+ and the SIM-CARD is done via the CCIO
pin5 by using CCCLK pin6 as a clock signal.
The diode V351 is used to protect CCCLK and CCIO versus switching peaks.
The display is provided with 2,65V from the ASIC D200. The communication with the
EGOLD+ is realised via the serial signals SCL and SI
To Next Page
Loading...
