EasyManua.ls Logo

Siemens AGM60.4A9 - Technical Data - AGM60; AGM60 Dual Fuel Switch Unit Specifications

Siemens AGM60.4A9
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26/30
Smart Infrastructure CC1N7544en
21.05.2021
Technical Data (cont´d)
Mains voltage
AC 120 V
-
15% / +10%
Mains frequency
50/60 Hz
±
6%
Power co
nsumption
<5 W (typically) (without
actuator supply)
Safety class I with parts according to II and III to
EN 60730
-
1
:
2
0
1
6
Galvanic separation between mains
voltage terminals and actuator signal lines
and actuator supply lines
No
Degree of protection IP00 according to EN 60529:1991 +
A1:2000 + A2:2013
Note:
The burner or boiler manufacturer (OEM)
must ensure degree of protection IP40 to
EN 60529:1991 + A1:2000 + A2:2013 for
burner controls by adequate installation of
the AGM60...
The AGM60 together with the LMV36 is
suited for installation under the burner
hood or inside a control cabinet or control
panel
Detection time fuel changeover
<400 ms
Switching frequency fuel changeove
r
Min. 3 s
Switching cycles fuel changeover
Max. 5´000
Permissible primary fuse (Si) (external) Max. 6.3 AT
Power must always be supplied via the
LMV36
(refer to chapter
I
nputs / Outputs
)
Caution!
Risk of damage to the switching contacts!
If the external primary fuse (Si) is blown due to overload or short-circuit at the
terminals, the
AGM60
must be replaced.
Mains supply:
Input current depending on the op
erating state of the LMV36
Mains voltage is monitored by the burner control
Dimensions (W x H x D)
180.7 x 120.7 x 51.7 mm
Mounting Top hat rail to DIN EN 60715,
35 mm or screwed
Status input: Fuel selection, pressure switch
Input currents and input voltages
- UeMax
- UeMin
- IeMax
-
IeMin
UN +10%
UN -15%
1.5 mA peak
0.7 mA peak
Contact material recommendation for
external switching contact,
transducer (pressure switch-max,
POC)
Gold-plated silver contacts
Transition / settling behavior / bounce
- Perm. bounce time of contacts
when switching on/off
Max. 50 ms (after the bounce time, the
contact must stay closed or open)
UN
AC
120 V
Voltage detection
- On
-
Off
AC 90...132 V
<AC 40 V
Dual fuel switch unit
AGM60
Termin
al output
I
n
puts

Other manuals for Siemens AGM60.4A9

Related product manuals