en Cleaning
22
Removing panels
1. Press on the left- and right-hand sides of the cover
(fig.°!).
2. Remove the cover (fig. ").
3. Lift out the inner panel (fig. #) and set it down
carefully on a flat surface.
4. If necessary, you can remove the condensate trough
for cleaning. To do this, open the appliance door
fully (fig. $).
5. Tilt the condensate trough up and remove it (fig. %).
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:Warning
Risk of injury!
■ Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
■ The hinges on the appliance door move when
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Risk of injury!
■ Components inside the appliance door may have
sharp edges. Wear protective gloves.
Fitting panels
1. Open the appliance door fully and refit the
condensate trough. To do this, insert the trough from
above and rotate it at the bottom (fig. !).
2. Push in the inner glass panel.
Before sliding the panel in, make sure that the
glossy side of the panel is on the outside and the
cut-outs on the left and right are at the top.
The panel must be sitting correctly at the bottom in
the retainer (fig. ").
3. Push the inner panel in at the top (fig. #).
4. Put the cover back in place and press on it until you
hear it click into place (fig. $).
5. Open the appliance door again fully.
6. Close the two locking levers on the left and right
(fig. %)
7. Close the appliance door.
2
1
1
To Next Page
Loading...
