Siemens CF62 - Call Setup

©
Siemens AG 2003, I:\Mobil\R65\CF62_Leopard_abgel._von MC60_Maguro\en\_von_itl\fug\CF62_fug_en_040422\A65_Setup.fm
69Setup
VAR Language: English; VAR issue date: 10-Februar-2004
right page (69) of CF62 Leopard en, A31008-H6050-A1-1-7619 (28.04.2004, 11:45)
Call setup
§Menu§KmKCall setup
KSelect function.
Hide ID b
When you make a call, your phone
number can be displayed on the
recipient's display (depending on
the service providers).
To suppress this display, you can
enable the "Hide ID" mode for all sub-
sequent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it (see
also page 22).
Divert
You can specify when calls should
be diverted to your mailbox or other
numbers.
Set up call divert (example):
The most common condition for call
divert is, for example:
All Unanswered
b
I
Select All Unanswered.
(Includes the conditions
Not reachable, No reply,
Busy, see below)
E
Press.
Set Select.
J
Enter the phone number
to which the caller will
be diverted (If not already
entered)
Or
· Select this phone number
from the Addressbook/
Phonebook or via §Mailbox§.
§OK§ Confirm. After a short
pause, the setting is con-
firmed by the network.
All calls
b
All calls are diverted.
n
Symbol in the top line of
the display in standby
mode.
Not reachable
Divert occurs if phone is switched off
or is out of range.