Siemens CFG3.F200 - Interfaces; Ethernet Interfaces; Screw Terminals; USB Interface (4 G Internet)

6
Interfaces
Ethernet interfaces
Plug
3 x RJ45, shielded
Interface type
10Base-T / 100Base-TX, IEEE 802.3 compatible
Bit rate
10/100 Mbps, autosensing
Protocol
BACnet on UDP/IP, Modbus TCP/IP, KNX IP, Haystack
over RESTful API, OPC UA, oBix, Sedona, and SQL.
Cabling, cable type
10 Mbps: Min. CAT3, shielded cable is recommended
100 Mbps: Min. CAT5, shielded cable is recommended
Cable length
Max. 100 m (330 ft)
Screw terminals, plug-in
Cu-wire or Cu-strand with wire end sleeve
1 x 0.6 mm ∅ to 2.5 mm
2
(22 to 14 AWG)
or 2 x 0.6 mm ∅ to 1.0 mm
2
(22 to 18 AWG)
Cu-strand without wire end sleeve
1 x 0.6 mm ∅ to 2.5 mm
2
(22 to 14 AWG)
or 2 x 0.6 mm ∅ to 1.5 mm
2
(22 to 16 AWG)
Stripping length
6...7.5 mm (0.24...0.29 in)
Screwdriver
Slot screws, screwdriver size 1 with shaft ø = 3 mm
Max. tightening torque
0.6 Nm (0.44 lb ft)
USB interface (4G internet connection)
Plug
Type A
Interface type
USB 2.0
Bit rate
480 Mbit
Max. load
500 mA
Max. cable length
5 m
Conformity
Ambient conditions and protection classification
Classification as per EN 60730
Automatic action
Control function
Degree of pollution
Overvoltage category
Type 1
Class A
2
III
Design
Suitable for use in protection class I or II systems