Siemens CL75 - Call Setup; Call Screening

47Settings
© Siemens AG 2003, C:\Daten_itl\Siemens\DTP-Satz\Produkte\CL75_Wega_1\output\SUG\CL75_2_en_050419_vz_pk_druck\S_WEGA_Setup.fm
Template: X75, Version 2.2; VAR Language: en; VAR issue date: 050405
right page (47) of CL75 SUG en, A31008-H1550-A1-2-7619 (17.05.2005, 09:24)
Call setup
C
¢
T
¢Call setup
¢Select function.
Hide ID b
If activated, your phone number
will not appear on the other party's
display (depending on the service
providers).
Call waiting b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify when calls should be
diverted to your mailbox or other
numbers.
Setting up call divert (example)
Unanswered
b
‘
Select Unanswered.
(Includes the conditions
Not reachable, No reply,
Busy, see below)
§Change§ Confirm and select §Set§,
then enter the phone
number to which the call
will be diverted.
§Change§ Confirm the network
setting.
All calls
b
All calls are diverted.
‘
Symbol in the top line of
the display when in stand-
by mode.
Other possibilities for divert: Not
reachable, No reply, Busy, Status check
and Clear all.
Call screening b
Only calls from phone numbers that
are in the Contacts or in a group are
signalled. Other calls are only dis-
played.
Any key answer
Incoming calls can be accepted by
pressing any key (except for
B
).
Minute beep
During the call, you (and only you!)
will hear a beep after each minute as
a reminder of the time elapsed.