Siemens CM 1542-1 - Requirements for Use; Project Engineering and Configuration Tools; Configuration Data Download Process

Properties and functions
1.4 Requirements for use
CM 1542-1
Operating Instructions, 07/2019, C79000-G8976-C355-04
17
1.4 Requirements for use
1.4.1 Project engineering
Software for configuration and online functions
To configure the CP, the following configuration tool is required:
STEP 7 version
Functions of the CM
STEP 7 Professional V13
Most functions of the CM can be configured.
STEP 7 Professional V14 The full functionality of the CM can be configured
with the new functions of the firmware version
according to Preface (Page 3).
Downloading the configuration data
When there is a download to the CPU, the CM is supplied with the relevant configuration
data. The configuration data can be downloaded to the CPU via a memory card or any
Ethernet/PROFINET interface of the S7-1500 station.