Siemens CM633GB 1M Series - Bakes and Soufflés Preparation; Microwave Bakes and Soufflés; Bake and Soufflé Shelf Positions and Cookware; Recommended Bake and Soufflé Settings

Installation instructions en
33
Microwave cooking
¡ If you use the wire rack, slide it into the cooking
compartment with the Microwave imprint facing the
appliance door and the bump pointing downwards.
¡ To test the microwave mode on its own, switch off
the drying function in the basic settings. →Page19
Recommended settings for defrosting food using the microwave mode
Food Accessories/cook-
ware
Shelf posi-
tion
Heating
function
→Page9
Microwave power
setting inW
Cooking time
in mins
Meat Uncovered cookware 1 ⁠ 1. 180
2. 90
1. 5
2. 10–15
Recommended settings for microwave cooking
Food Accessories/cook-
ware
Shelf posi-
tion
Heating
function
→Page9
Microwave power
setting inW
Cooking time
in mins
Egg wash Uncovered cookware 1 ⁠ 1. 360
2. 180
1. 20
2. 20–25
Sponge Uncovered cookware 1 ⁠ 600 7–9
Meat loaf Uncovered cookware 1 ⁠ 600 22–27
Recommended settings for cooking in combination with the microwave mode
Food Accessory/cook-
ware
Shelf pos-
ition
Heating
function
→Page9
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Potato gratin Uncovered cook-
ware
1 ⁠ 150 - 170 360 25 - 30
Cakes Uncovered cook-
ware
1 ⁠ 190 - 210 90 18 - 23
23 Installation instructions
Observe this information when installing the appliance.
23.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡ The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡ Ventilation slots and intake openings must
not be covered.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95°C, and adjacent unit fronts up to
70°C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.