Siemens CM724G1 1 Series - Customer Service

Troubleshooting en
27
Fault Cause and troubleshooting
The appliance is not
working.
Electronics fault
1.
Briefly disconnect the appliance from the power supply by switching off the fuse.
2.
Reset the basic settings to the factory settings.
→"Basic settings", Page19
"Sprache Deutsch"
appears in the dis-
play.
There has been a power cut.
▶
Configure the initial configuration settings.
→"Performing initial start-up", Page12
The operation does
not start or is inter-
rupted.
Different causes are possible.
▶
Check the notifications that appear on the display.
→"Displaying information", Page13
Malfunction
▶
Call the after-sales service.
→"Customer Service", Page28
Appliance does not
heat up.
Demo mode is switched on.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
2.
Switch off demo mode in the basic settings within approx.5minutes.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→"Basic settings", Page19
HomeConnect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600W
or 900W. The cooking result is not affected by this.
▶
You can change the basic setting for the drying function during microwave operation.
→"Basic settings", Page19
‒ Observe the information on operating with microwave.
→"Microwave", Page15
The interior lighting
does not work.
The LED light is defective.
▶
Call the after-sales service.
→"Customer Service", Page28
Maximum operating
time reached.
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using ⁠. Reset and start
the operation.
2.
If you do not need to use the appliance, press ⁠ to switch it off.
Tip:To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→"Time-setting options", Page14
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page28