Siemens CP 1543-1 - c(UL)us Certifications Overview

Approvals
CP 1543-1
Operating Instructions, 05/2017, C79000-G8976-C289-07
61
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find here:
● In the SIMATIC NET Manual Collection in
"All documents" > "Use of subassemblies/modules in a Zone 2 Hazardous Area"
● On the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
EMC
Until 19.04.2016 the product meets the requirements of the EC Directive 2014/30/EU
"Electromagnetic Compatibility” (EMC directive).
Applied standards:
● EN 61000-6-4
Electromagnetic compatibility (EMC) - Part 6-4: Generic standards - Emission standard
for industrial environments
● EN 61000-6-2
Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - Immunity for
industrial environments
RoHS
The product meets the requirements of the EC directive 2011/65/EU on the restriction of the
use of certain hazardous substances in electrical and electronic equipment.
Applied standard:
● EN 50581:2012
c(UL)us
Applied standards:
● Underwriters Laboratories, Inc.: UL 61010-1 (Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements)
● IEC/UL 61010-2-201 (Safety requirements for electrical equipment for measurement,
control and laboratory use. Particular requirements for control equipment)
● Canadian Standards Association: CSA C22.2 No. 142 (Process Control Equipment)
Report / UL file: E 85972 (NRAG, NRAG7)
cULus Hazardous (Classified) Locations
Underwriters Laboratories, Inc.: cULus IND. CONT. EQ. FOR HAZ. LOC.