Siemens CP 5711 - Page 22

Hardware installation
3.4 Installing on a DIN rail
CP 5711
22 Operating Instructions, 02/2018, C79000-G8976-C283-05
1. Push the DIN rail holder into the profile on the rear of the CP.
2. Place the upper DIN rail holder on the upper edge of the DIN rail so that the PROFIBUS
connector points down.
3. Pull down the DIN rail slide and hold it in position.
4. Press the lower DIN rail holder against the lower edge of the DIN rail.
5. Release the DIN rail slider.
The catch in the lower DIN rail holder locks onto the DIN rail.
Removing the communications processor from the DIN rail
To release the locking mechanism in the lower DIN rail holder, pull the DIN rail holder down.
If necessary use a screwdriver or pliers.